Simaudio Neo 430HA Headphone Amplifier Manuel d'utilisateur télécharger pdf (Page 13)

430HA Headphone Amplifier

____________________________________________________________________________________

Operating the 430HA

We recommend leaving your Nēo 430HA powered

up at all times to maintain optimal performance.

When you plan on being away for a few days, it may

not be a bad idea to power off your preamplifier.

Please keep in mind that once fully “broken-in”, your

430HA requires several hours of operation before

reaching optimal performance after powering it up

again.

Turning on your Nēo 430HA for the first time

Prior to turning the headphone amplifier on for the

first time, make sure that every cable is properly

connected to avoid any problems. Flick the main

rocker switch, located on the rear panel, labeled

“POWER” to the ‘1’ (on) position to place your

430HA in to standby mode. Next, briefly press the

push button labeled “Standby” located on the front

panel. You will hear a very faint click sound

confirming that everything is in order. The blue LED

on the front panel will illuminate, indicating that the

430HA is now powered up and ready for use.

On and Off Sequence

To avoid having any annoying noises (ie. “thumps”

and “pops”) emanate from your headphones when

powering your 430HA on or off, you should always

power up your source component(s) (CD, DAC,

Streaming Device) prior to powering up your

430HA. As well, always power down your 430HA

before powering down your source component(s).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Simaudio Neo 430HA Headphone Amplifier Manuel d'utilisateur Page 13