Simaudio Neo 430HA Headphone Amplifier Manuel d'utilisateur télécharger pdf (Page 14)

430HA Headphone Amplifier

____________________________________________________________________________________

Remote Control Operation

The Nēo 430HA Headphone Amplifier uses the ‘CRM-2’ full-function remote

control (figure 3). It operates on the Philips RC-5 communication protocol

and can be used with other Simaudio MOON componen

ts.

The ‘CRM-2’ remote uses two AA batteries (included). To install them,

simply slide the back plate off in the direction of the arrow; insert the

batteries in the correct direction and then replace the back plate.

To engage the ‘CRM-2’ remote for use with the Nēo 430HA Preamplifier,

you must first press the button labeled AMP.

The POWER button located on the upper left will switch the Headphone

Amplifier to either ‘Standby’ or ‘On’ mode.

The DISPLAY button turns the front panel display on and off

The 2 buttons labeled ◄ INPUT ► allow you to sequentially scroll, either

backwards or forwards, through all available inputs. For example, to switch

from the “A1” to the “B1” input, press ◄ INPUT two (2) times. To switch

from the “B1” to the “A1” input, press INPUT ► two (2) times. Pressing and

holding down either of these buttons results in only a single change to the

selected input.

The 2 buttons labeled ▼ VOL ▲ allow you to control the volume level.

Pressing ▼ VOL results in a decrease in the volume level; Pressing VOL ▲

results in an increase in the volume level. You may either press and hold

these buttons down or press them briefly to make volume adjustments.

The MUTE button turns off the output volume. Pressing the “Mute” button a

second time will reinstate the output volume level back to its current setting.

NOTE: The ◄ BAL ► buttons don’t affect the operation of the 430HA.

Figure 3: CRM-2

Remote Control

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Simaudio Neo 430HA Headphone Amplifier Manuel d'utilisateur Page 14